8
UP Button
– Depress and hold the UP button to run the power unit and raise the forks. From a fully lowered position, the forks will rise to the
maximum pallet jack height and stop. To continue, it is required that the UP button be released and then depressed. Their will be a 6 second
delay while the outriggers rotate to their extended positions. When the outriggers are completed extended, the power unit will run again and the
forks will continue to rise. Raise the forks to the desired height and release the UP button. To avoid damaging the outriggers, ALWAYS ensure the
outriggers are either in the fully retracted or the fully extended positions. NEVER leave an outrigger partially extended while moving the UniLift.
DOWN Button
– Depress and hold the DOWN button to lower the forks. When lowering from a raised height above 10 inches (254 mm) the forks
will stop automatically and rotate each outrigger to its retracted position (6 second delay). Continue to hold the DOWN button to lower the forks to
the desired height. ALWAYS ensure the outriggers are either in the fully retracted or the fully extended position. NEVER leave an outrigger partially
extended while moving the UniLift.
Key / Battery Disconnect Switch
– Turning the key to the OFF position disconnects all battery power from the UniLift. Turn the key to the ON
position to connect battery power to the UniLift’s control system.
Outrigger Position LEDs
– The position of each deployable outrigger is indicated by 5 LEDs (2 green and 3 red LEDs). A green LED indicates the
outrigger is in either the fully retracted or the fully extended position. The red LEDs indicate an outrigger is moving between positions, is stopped in
between positions or has struck an obstruction. The various outrigger positions with the associated LED indications are illustrated below in Figures
8 – 17.
Figure 7 Operator Console
Figure 8 Outriggers Fully Retracted LED Indicators
Figure 9 Right Outrigger Extending LED Indicators
Outriggers Fully Retracted
– The two lower green LEDs
will be illuminated when both outriggers are fully retracted.
The UniLift is in PALLET JACK mode and is capable of
lifting, lowering and transporting a palletized load as a
pallet jack.
Right Outrigger Extending
– As the UniLift transitions
from a pallet jack to a stacker, the right 3 red LEDs will
scroll outward indicating the right outrigger’s direction of
movement. While depressing the UP button, the right
outrigger will rotate from the fully retracted position to the
fully extended position in approximately 3 seconds. During
this time the LEDs will continue to scroll outward.
