6
FUNCTIONAL DESCRIPTION
The UniLift is a dual purpose pallet positioner and transporter designed to improve palletizing productivity and worker safety. The UniLift allows
palletized loads to be transported like a pallet jack then lifted like a stacker. It rolls, steers and maneuvers like a typical pallet jack allowing easy
transport and precise positioning. From the maximum pallet jack height, the UniLift will quickly transform into a high lift stacker. Release and
depress the UP button again and each of the UniLift’s deployable outriggers will rotate into position to provide high lift load support. Unlike a
straddle stacker, the outriggers do not straddle the load allowing access from three sides. The palletized load can now be raised to a convenient
working height.
Figure 4 Functional Drawing
UNPACKING THE UNILIFT
The UniLift is shipped on an oversized pallet and only requires removal from the pallet and charging before it is ready for use. Although removal
from the pallet is a simple process, certain precautions must be taken to ensure product damage does not occur.
Tools Required
•
Banding or strap cutters
•
Knife or single sided razor blade
•
#2 Phillips screwdriver or battery drill
• Hammer
•
3/16 inch Hex Key or Allen Wrench
(overhead hoist instructions only)
• 5/8-11
Eyebolt
(overhead hoist instructions only)
Equipment Required
•
Forklift or overhead hoist
Forklift Unpacking Instructions
1.
Using a forklift or similar equipment, move the palletized UniLift to a convenient location with suitable work area. The area should be clean
and have good general lighting.
2.
Next, using the strap cutter, remove the bands securing the UniLift to the pallet. Remove all packing material and place it off to the side.
3.
The UniLift is stabilized on the pallet with two (2) shipping blocks secured to the top of the pallet on the left and right side of the UniLift.
Remove the screw securing each block to the pallet, then tap the side of the blocks to remove them from the pallet.
4.
Next, spread the forklift forks to their maximum width. The width between the forks should be approximately 24 inches (610 mm).
5.
As shown in Figure 5, insert one forklift fork under the center of the base frame behind the retracted outriggers and the other fork under the
UniLift’s forks. Use care when inserting the forks and ensure the fork under the base is not contacting the retracted outriggers.
6.
Gently lift the UniLift off the pallet and set it on the fl oor.
Overhead Hoist Unpacking Instructions
1.
Using a pallet truck or similar equipment, move the palletized UniLift to a convenient location with suitable work area. The area should be
clean and have good general lighting.
2.
Next, using the strap cutter, remove the bands securing the UniLift to the pallet. Remove all packing material and place it off to the side.
3.
Using a 3/16 inch hex key wrench, remove the two (2) button head cap screws that secure the top cover to the mast. Place the mast top
cover off to the side.
4.
Thread the 5/8-11 eyebolt into the access hole on the top of the mast. Ensure there is a minimum of 1 inch of thread engagement.
5.
Next, attach a lifting sling or chain to the eyebolt and carefully lift the UniLift off the pallet. Slide the pallet to the side and gently lower the
UniLift to the fl oor.
6.
Reposition the mast cap on top of the mast and reinstall the two (2) screws.
