ー 13 ー
Waring
Do not lift up any load which is heavier than lift's Capacity.
Lift could be broken.
Make sure there is no one and nothing around lift before operation,or it could result in serious
accident.
Danger
Do not go under vehicle during operation.
If not, it may result in personal injury accident.
Caution
Make sure that Drive-on Plates are fully lowerd before vehicle exit.
If not, it may result in damaging vehicle and Lift.
3. Lifting
5. Vehicle Exit
4. Lowering
1 Push "UP" button switch and lift up Drive-on Plates. Stop the operation just
before Side Sill Blocks touch lifting points of vehicle. Then check again if the
Blocks are positioned under lifting points.
2 If not, adjust them to proper position.
3 If they are, lift up Drive-on Plates until tires of vehicle come off from the ground
(about 2-3cm).
4 Swing vehicle up and down gently and slowly in order to check if vehicle is well-
balanced. If so, lift vehicle up to the height for work.
5 Release "UP" button immediately when Drive-on Plates reach max. height.
・ Push "DOWN" button. Then Lowering Stop Hook get released and Drive-on Plates
lower. When you stop pushing the button, Drive-on Plates stay in that height level,
and Lowering Stop Hooks get hooked in Lowering Stop Racks.
・ If Lowering Stop Hooks do not get released because they are deeply hooked in, lift
up the Plates a little and push "DOWN" button again.
1 In case that Adjustable Drive-on Plates are extended, stop lowering once when
tires of vehicle reach the ground and the Plates leave off from vehicle.
2 Remove Side Sill Blocks and return the Plates to minimum lengths.
3 Restart lowering the Plates again to the bottom.
Make sure that there is no tools or other objects under vehicle and inside of pit
before vehicle exit.
