10
To be able to push the scooter manually, pull the clutch
switch upwards. This is necessary if the battery is flat.
Please follow the steps below:
• Before switching on the battery charger check that the
power supply is 115V or 230V.
• Please set the AC power switch to "0" before charging
the battery.
• Once you have done this, switch the AC switch to “I”.
The fan will switch on and the LED display will show
the red and yellow light (see Fig. 14), and the normal
charging process starts. If you see irregular signals,
switch the device off and repeat steps 1-4 and start
charging again.
• Charging takes approx. 5 to 6.5 hours. When charging
is complete, a green light will appear.
Please note the following items
• Please make sure that you charge your scooter
on dry ground only.
• Incorrect voltage and batteries are hazardous
and may damage the battery.
• Switch the charger module to “O” before connecting
the charger cable to the battery.
• Do not expose charger to from rain, water or steam.
• Please contact your dealer if the charger module still
shows "yellow" after charging for more than 12 hours.
Fig. 12
Fig. 13
