25
CONNECTION INSTRUCTIONS FOR TANDEM OPERATIONS
AFMG-48 or AFMG-52 INTO AFMG-48 or AFMG-52
Heavy Horsepower Grinder INTO AFMG-48 or AFMG-52
Step 2. Install the Inlet Tube Seal Item No. 53671 or 57145 into the inlet
tube of the Second Grind Machine until fully seated.
Step 3. Remove the Ring from the First Grind Machine, Item No. HR42/48 or HR52. Insert the Discharge
Horn, Item No. 57144-7 or 57143-7 into the ring. (DO NOT reinstall the ring on the First Grind
Machine at this time.) Slide the Clamp Assembly, Item No. 57144-11 or 57143-11 onto the
Discharge Horn.
Step 4. Insert the Discharge Horn with Ring and Clamp Assembly
into the Seal, pushing it fully against the inlet tube internal
fins. Attach the lock latches to the tabs on the side of the
inlet tube and lock down. Tighten the lock knob on the
Clamp Assembly.
Step 5. Move the Discharge Horn of the Second Grind Machine up to the Bowl of the First Grind
Machine. With the Auger, Knife and Grinding Plate installed in the First Grind Machine, thread
the Ring onto the First Grind Machine Bowl.
RING SHOULD BE HAND TIGHTENED ONLY: USE NO TOOLS.
Step 1. Remove Lock Knobs, Item No. 14688; Outer disc, Item No. 54303 and Side Entrance Seal,
Item No. 57133 from the inlet tube of the Second Grind Machine. Clean out the tube if necessary.
