BIRO AFMG-48-II, Operating And Service Manual, Page: 29 / 36

CONNECTION INSTRUCTIONS
TANDEM OPERATIONS
AFMG-48 or ARFMG-52 INTO AFMG-48 or AFMG-52
Heavy Horsepower Grinder INTO AFMG-48 or AFMG-52
23
Remove Side Entrance Seal, Item No. 57133; Outer Disc, Item No. 54303 and
Lock Knobs, Item No. 14688 from the inlet tube of the Second Grind Machine.
Clean out the tube if necessary.
Install the Inlet Tube Seal Item No. 53671 or 57145
into the inlet tube of the Second Grind Machine until
fully seated.
Remove the Ring from the First Grind Machine, Item No. HR42/48 or HR52. In-
sert the Discharge Horn, Item No. 57144-7 or 57143-7 into the ring. (DO NOT
reinstall the ring on the First Grind Machine at this time.) Slide the Clamp Assem-
bly, Item No. 57144-11 or 57143-11 onto the Discharge Horn.
Insert the Discharge Horn with Ring and Clamp Assembly
into the Seal, pushing it fully against the inlet tube internal
fins. Attach the lock latches to the tabs on the side of the
inlet tube and lock down. Tighten the lock knob on the
Clamp Assembly.
Move the Discharge Horn of the Second Grind Machine up to the Bowl of the First
Grind Machine. With the Auger, Knife and Grinding Plate installed in the First
Grind Machine, thread the Ring onto the First Grind Machine Bowl.
RING
SHOULD BE HAND TIGHTENED ONLY: USE NO TOOLS.
26