Any question, please call CUSTOMER SERVICE 1-800-454-2588
Model: EHUV-10-03
10
Press the MODE button to select WARM or WARM and UV purification mode. The “WARM”
(“WARM” and “UV”) indicator will light up. The “HUM” indicator under HEATING button also light
up as the unit gives warm air and humidity simultaneously.
Press the HEATING button to select your desired warm air level; HIGH or LOW.
Press the SPEED button to select your desired fan speed.
Press OSCILLATE to select your preferred air flow direction, e.g. air swing from left to right, or
fixed direction of air flow.
Check water level in water tank during operation. Once water below minimum level, turn off
power button and Main Power Switch. Then refill the water tank with fresh water in the tank.
Please refer to procedures to fill up water tank.
To turn off the unit, press the POWER button again. If you do not intend to use the product for
some time also turn off the Main Power Switch after the product has stopped. Empty the water
tank after turning off the Main Power Switch.
NOTE:
This unit is built with Automatic Humidistat Control. You can set your desired RH% (Relative Humidity
%) by pressing the HUMIDITY button. The adjustable range is from RH 30% to RH 70%. The RH% will
be adjusted in unit of 5%.
When the room RH (Relative Humidity) has been brought up to your set RH%, the unit will stop
humidifying function. When the room RH% drops below your set RH%, the unit will restart humidifying
function automatically. Air washer function is working whenever water is pumping through the system.
If you do not set RH%, the unit is preset at RH 50%. The adjustable range is RH 30% to RH 70%.
Humidifying is suggested for use while the RH% is below 20% as such low humidity level can be
unhealthy and uncomfortable. The recommended humidity level is 40% to 50%. This unit gives a cool,
invisible moisture output. It is normal not to see the mist.
TIMER OPERATION
The Timer can be used to switch the unit off after a selected number of hours.
Select the desired operating mode.
Press the TIMER button once and the unit will switch off after 1 hour. Press the button again for
2 hours, again for 3 hours etc. The maximum timer setting is 8 hours.
To cancel the Timer setting press the TIMER button again until all the timer indicators light off.
OSCILLATE OPERATION
Press the OSCILLATE button to start the louvers moving from side to side. This will improve the
distribution of the cooled or warmed air in the room. To stop the oscillation, press the
OSCILLATE button again until indicator light off.
You can change the air direction (up or down) by manually adjusting lever alongside the
horizontal louvers.
Summary of Contents for EHUV-10-03
Page 1: ......
