Biotage Selekt Enkel, User Manual

Page: 5 / 44

3
System Overview
The status for each solvent detector connected to the system is
displayed in the
About view; see Figure 7.
Figure 7. The status of the solvent detectors are displayed in the About
view. Gray = no solvent detector connected, green = no leak detected,
and red = leak detected.
UV Detector
The system includes a 200 to 400 nm UV detector.
Collection and Fractionation Methods
Available detection signals are:
»
λ
-All:
The system uses average absorbance
within a user-defined wavelength range for
collection and fractionation. Only available on
systems with a Spektra software license.
»
UV1 and UV2: The system uses one or two wavelength
signal(s) for collection and fractionation.
Possible collection and fractionation parameters are
Collect All, Threshold, and Valley Fractionation. The system
always fractionates on volume, which is when a test tube or
bottle reaches the specified vessel volume or a user-defined
maximum fraction volume for the run. At any time, you can
manually switch to a new collection vessel by pressing in
the chromatogram.
Any signal combination can be used for collection and
fractionation. Signals that are not used for collection can be
used for monitoring.
Figure 8. The expanded Collection panel.
Network Share
N
With the system connected to the network, it is possible to give
the system access to a network share folder. The share folder
can be used for:
»
Backup and restore of the system’s database.
»
Export of reports and system logs; see Figure 9.
»
Automatic export of the report each time a run
is completed, i.e. the reports are saved both on
the system and in the network share folder.
The system will create a subfolder in the share folder with
a name that includes the system’s serial number (Selekt
_
serialnumber). In this way the share folder can be used by
several systems.
Figure 9. The Export dialog on a system with all export options enabled. N