Chapter2
BIOS Setup
2-34
2.12 Set Supervisor / User Password
Figure 12. Set Supervisor / User Password
CMOS Setup Utility-Copyright (C ) 1984-2000 Award Software
►
Standard CMOS Features
►
Frequency/Voltage Control
►
Advanced BIOS Features
Load Fail-Safe Defaults
►
Advanced Chipset Features
Load Optimized Defaults
►
Integrated Peripherals
Set Supervisor Password
►
Power Management Setup
Set User Password
►
PnP/PCI Configurations
Save & Exit Setup
►
PC Health Status
Exit Without Saving
Esc : Quit F9 : Menu in BIOS
: Select Item
F10 : Save & Exit Setup
Change/Set/Disable password
When you select this function, the following message will appear at the center of
the screen to assist you in creating a password.
ENTER PASSWORD
Type the password, up to eight characters, and press <
Enter
>. The password you
type now will clear any previously entered password from CMOS memory. You
will be asked to confirm the password. Type the password again and press
<
Enter
>. You may also press <
ESC
> to abort the selection and not enter a
password. To disable password, just press <
Enter
> when you are prompted to
enter password. A message will confirm that you wish to disable the password.
Once the password is disabled, the system will boot and you can enter setup
freely.
Enter Password:
