4
1. Safety Precautions
The following symbol means:
Caution:
Make sure you have fully read and understood the present Manual
before using the equipment. Please pay special attention to sections
marked by this symbol.
GENERAL SAFETY
Use only as specified in the operating manual provided.
Save the unit from shocks and falling.
Store and transport the unit at ambient temperatures between -20
°C and +60°C and
maximum relative humidity of 80%.
After transportation or storage, keep the unit under room temperature for 2 to 3 h
before connecting it to the mains.
Before using any cleaning or decontamination methods except those recommended
by the manufacturer, check with the manufacturer that the proposed method will not
damage the equipment.
Do not make modifications in design of the unit.
Do not place the optic parts under direct light.
ELECTRICAL SAFETY
Connect only to an external power supply with voltage corresponding to that on the
serial number label.
Use only the external power supply provided with this product.
Ensure that the power switch and external power supply are easily accessible during
use.
Disconnect the unit from the external power supply before moving.
This equipment is connected and controlled by PC. Please ensure that the attached
PC itself conforms to safety and EMC standards.
If liquid penetrates into the unit, disconnect it from the external power supply and
have it checked by a repair and maintenance technician.
Do not operate the unit in premises where condensation can form. Operating condi-
tions of the unit are defined in the Specifications section.
DURING OPERATION
Do not operate the unit in environments with aggressive or explosive chemical mix-
tures. Please contact manufacturer for possible operation of the unit in specific at-
mospheres.
Do not operate the unit if it is faulty or was installed incorrectly.
Do not use outside laboratory rooms.
Set up the PC display with the correct viewing position, free from glare and with ap-
propriate brightness and contrast settings.
Close the lid after placing or removing the microplates.
Do not open the lid during measurements.
BIOLOGICAL SAFETY
It is the user’s responsibility to carry out appropriate decontamination if hazardous
material is spilt on or penetrates into the equipment.
