5c. Setting the Date and Time
To set the Date and Time on your Ovulation Thermometer, you need to sync
the thermometer to the PrecisionTemp App on your mobile or tablet device.
1. Press the power button located on the front of the
thermometer.
, time and date icons and --/-- will
appear on the screen, they will flash and beep three times.
Then
On
and the will appear on the screen and will
continue to flash until it is paired with the PrecisionTemp
Ovulation App.
2. On the home screen at the top you will see PrecisionTemp
Status: Pull down to pair. Slide your finger down the home screen on
the App and via Bluetooth it will start to locate your thermometer. Once
the two have connected, you will see App flash on your Digital Ovulation
Thermometer and then the word OFF. The thermometer will then turn off
indicating that the two units are sync’d and both are ready to be used.
NOTE: when you change the battery in your Ovulation Thermometer the
above pairing will have to be re done.
5d. Using the Thermometer
ORAL METHOD
Since temperatures taken at different sites of the body can vary, it is important
to select one method and then take your temperature the same way every
day. You must use either the oral, vaginal or rectal method. Using more than
one method will provide inaccurate results. Select oral, vaginal or rectal as
your measurement based on professional recommendation.
1. Power up the thermometer and
On
will appear on the screen
and a short beep will be heard, then the display will go
through its calibration test.
2. Once the calibration test is complete the thermometer
will beep again and the last measurement will be displayed.
The thermometer will beep again and ---- will be flashing
on the screen. The thermometer is now ready to take a
measurement.
3. Place the sensor tip well under the tongue as indicated by the
“ ”. (see
Figure 1
).
4. The peak temperature should be reached in approximately 60 seconds.
Opening the mouth or improper placement of the probe tip could result in a
longer time for a reading.
5. When the peak temperature is reached, the reading and the “°C” symbol
will stop flashing, and the thermometer will beep.
6. The Bluetooth function will automatically turn on and sync with your
PrecisionTemp App. This will download your current temperature to your
APP for the current day for charting purposes.
7. Push the power button to turn the unit off. If you do not turn the unit off, it
will shut off automatically in approximately 1 minute.
Figure 1
