NOTE
: Make sure the following contents have been included with your HWS for mounting the transmitter:
• 2 x 1.75" wall mounting screws
• plastic anchors for screws
Wall Mount
1. Affix the wall bracket onto a desired wall using the 1.75" screws provided
2. Insert the plastic plug on the back of the thermometer-transmitter sensor into the wall bracket socket.
Vertical Mount
1. Affix the wall bracket onto a flat, horizontal surface using the 1.75" screws provided.
2. Plug in the thermometer-transmitter using the plug found on the bottom of the sensor into the wall bracket
socket.
DO NOT
mount the thermometer-transmitter sensor upside down.
6. CONNECTING THE SENSOR
Thermometer-Transmitter Sensor
You must insert the cables that run from the outdoor sensors into the corresponding sockets on the thermometer-
transmitter before you can begin to power up your HWS.
1. You will see three sockets: one for the wind sensor, one for the wired transmission, another for the rain sensor
(see Diagram C).
2. Connect the cables of the wind and rain sensors to the corresponding sockets
on the thermometer-transmitter by 'clicking' them into place.
7. POWERING UP YOUR HWS WITH PC INTERFACE
For best results it is recommended that the thermometer-transmitter sensor is
directly linked to the home monitor using wired phone cord. (Section 12: Wired
Transmission). There is a smaller chance of the HWS loosing transmission signal
because of interference.
NOTE
: The AC/DC adaptor should be used as the primary power source for the
home monitor and batteries should only be used for back up purposes in case
of a power outage.
9
WALL MOUNT
VERTICAL
MOUNT
Diagram
Diagram C
Wired
Transmission
