Project Type
Instructions
Date: October 30 2020
Customer: Thermor Ltd
Job Number: TH4674
Item Number: BD201
Designer: Natalia Sigenza
PO: 24797-00
Revision: A
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor office with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
Colour Breakdown
Reason For Project:
New Item:
New Branding:
Design Update:
N/A: X
UPC (For Reference Only)
c) Pull the cuff and tighten it by attaching the Velcro
®
fastener.
d) The cuff should fit snugly around the bare arm, but not too
tight. You should be able to fit two fingers under the cuff.
If the cuff is the wrong size, the device will not measure
your blood pressure accurately. Contact the store, or BIOS
Medical for other sized cuffs.
e) Place the arm on the table (palm facing upwards) so that the
cuff is at the same level as the heart. Make sure there is no
kink in the hose.
f) You can adjust the level of your arm by putting a cushion
under your arm. Ideally the cuff should be at heart level.
g) Remain seated in a comfortable room temperature for at
least 5 minutes, then start the measurement.
h) For those who cannot put the cuff on the left arm, put it on
the right arm as shown.
i) Consecutive measurements will cause blood
accumulation in the lower arm which will affect the
measuring results. To improve reading accuracy, raise
the arm being measured, squeeze and relax your hand
several times, then take another measurement. Another
option is to take the cuff off and wait at least 5 minutes
before repeating measurement.
j) If this device was stored in low temperature, it is necessary to leave it in room temperature for at least
1 hour, otherwise the measurement can be inaccurate.
Comment:
Continue to use the same arm for comparisons. It is not unusual for there to be a difference in blood
pressure between arms.
Comparable blood pressure measurements always require the same conditions (Relax for several minutes
before taking a measurement).
ATTENTION: Do not use a cuff other than the original cuff contained in this kit!
c)
d)
e)
f)
h)
i)
