Project Type
Instructions
Date: October 30 2020
Customer: Thermor Ltd
Job Number: TH4674
Item Number: BD201
Designer: Natalia Sigenza
PO: 24797-00
Revision: A
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor office with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
Colour Breakdown
Reason For Project:
New Item:
New Branding:
Design Update:
N/A: X
UPC (For Reference Only)
2.3 Inserting Batteries (not included)
Follow these steps to insert four “AAA” batteries in the
device.
1. Open the battery compartment cover in the direction
shown.
2. Insert four “AAA” batteries with the correct polarity
as indicated.
3. Replace the battery compartment cover.
Attention!
• After the battery warning
appears, the device is
blocked until the batteries have been replaced.
• Please use “AAA” Long-Life or Alkaline 1.5V batteries.
• If the blood pressure monitor is left unused for long periods, please remove
the batteries from the device.
• Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc)
or rechargeable batteries.
2.4 Using an AC/DC Power Adapter (not included)
You may also operate this monitor using an AC/DC
adapter.
1. Ensure that the AC/DC adapter and cable are not
damaged.
2. Plug the adapter cable into the AC/DC adapter port
on the right side of the blood pressure monitor.
3. Plug the adapter into your electrical outlet. When the
adapter is connected, no battery current is consumed.
NOTE:
AC Adapter power source - 6V D.C. 600mA
3. Using the Device
This section describes how to get the maximum benefit from your BD323 blood pressure monitor. Follow
the instructions carefully to get an accurate measurement of your blood pressure and pulse rate.
IMPORTANT
: If you are using the monitor for the first time remove the protective film from the blood
pressure screen.
3.1 Measurement Mode Selection (3X or Single)
Clinical studies demonstrate taking multiple blood pressure readings and calculating an “average” is
more likely to determine your true blood pressure. Your blood pressure monitor allows you to switch the
monitor to 3X averaging mode that will automatically take multiple readings consecutively.
3X Averaging Mode
1. If you would like to take a 3X Averaging measurement, when the monitor is off press and hold the
MEM
button until you see “
nor
” on the screen. Press the
START/STOP
button to switch to 3X
Averaging, you will see “
tHr
” on the screen. Press
MEM
button to confirm.
nor – single measurement
tHr – multiple measurements (3X Averaging)
