Bionet Oxy9Wave Vet, Operation Manual

Page: 26 / 48

Oxy9Wave Vet
Operation manual
Ver. 1.52 4.Operation 26
4-4-2. Sensor Attached
The monitor displays dashed (-- --), indicating the “ Lead Fault ” message.
[ When the Sensor is Attached ]
When a sensor is attached to the monitor, the sensor status is displayed on the monitor.
The monitor displays a bar in the %SpO
₂ and the Pulse Rate while Oxy9Wave Vet is searching
for a valid pulse. Once a valid pulse is detected, the monitor shifts to Monitoring Mode and
displays the patient parameters. Check for the movement of the level bar or waveform, which
indicates that the monitor is displaying real-time data.
< Sensor Message >
1. Sensor is not connected to a patient : Check Probe
2. Sensor is connected to a patient (searching a pulse) : Pulse Search
3. During normal measurement after the sensor is connected : Message is not displayed.
4. Sensor is moving too fast during measurement : Artifact signal