Bionet BM Elite Series, Instructions For Use Manual

Page: 151 / 215

Rev. 5.01
151
16. Printer
Overview
The monitor allows the user to print out monitoring data, including trends and alarm data.
Recordings of waveforms are either timed or continuous and print at a recording speed of 25mm/s.
All recordings are identified by the animal’s name, ID as well as the date and time of the recording
request. The monitor can trigger alarm recordings automatically for life-threatening alarms and limit
violations, if the Record function is enabled on the alarm limits table.
A printer used to print data onto thermal paper: Size of the thermal paper roll: 58mm wide x 38mm
in diameter. Any thermal paper of same size can be used for the printer.
Caution
Due to the nature of thermal paper, it generates heat when continuously
output, so it is recommended to output after 5 minutes of output and after
10 minutes of idle time.
Printer Settings
Menu Description Available settings
A. Print Setup menu
A-1.
Printer setup
A-1-1. Use of printer Printer activation ON / OFF
A-1-2. Printer speed Printer speed select
25 mm/s
50 mm/s
A-1-3. Waveform1 Channel 1 waveform select OFF, SPO2, RESP,
ETCO2, LEAD I, LEAD
II, LEAD III, aVR, aVL,
A-1-4. Waveform2 Channel 2 waveform select