Bionaire BCH001X, Instruction Manual, Page: 5 / 92

5
• WARNING
: Risk of Fire. Discontinue use
if the outlet or plug become hot to the touch.
Overheating may indicate a worn or damaged
outlet. Consult a qualified electrician for outlet
replacement.
PARTS
A. Digital control panel H. Increase button
B. Ceramic front grill (for BCH001X only) I. Decrease button
C. Front grill (for BFH004X only) J. Timer button
D. Oscillation base (for BFH004X only) K. Timer indicator light
E. High/Low Heat button L. Fan Only button
F. Frost Guard icon M. LCD display
G. Temperature Set button N. Oscillation button (for BFH004X only)
OPERATING INSTRUCTIONS
1. Place your heater on a firm level surface.
2. Plug your heater into a wall socket. Once
plugged in the heater is in Standby mode.
CAUTION : THE FRONT GRILL IS HOT WHEN THE
HEATER IS IN OPERATION.
Standby Mode
When in Standby mode, the LCD display will cycle
through the following positions.
NOTE: The heater will return to Standby mode if you
press the Fan Only button, the HI/LO button or the
Temperature Set button while the heater is already
running in one of these modes.
Fan Mode
Press the Fan Only button
L
to operate your heater
without any heat output. The LCD display will cycle
through in this mode.
Low/High Heat Mode
1. Press the HI/LO button
E
once to operate your
heater continuously at the low heat setting. The
LCD display will show .
2. Press the HI/LO button
E
a second time to
operate your heater at the high heat setting. The
LCD display will show .
3. Press the HI/LO button
E
a third time to return
the heater to Standby.
Temperature Mode
Your heater is equipped with a digital thermostat that
allows you to set your heater to a precise comfort
control level. In this mode the heater will operate in
the high heat setting.
1. Press the Temperature Set button
G
once. The
LCD display will flash “29” (29°C). If you do not
press another button after 5 seconds, the LCD
display will stop flashing and your heater will then
start to operate and maintain a room temperature
of 29°C.
2. To select a temperature from 16°C to 29°C,
press the Decrease button
I
or the Increase
button
H
as required.
The LCD display will show the selected
temperature. When the room temperature drops
below the preset temperature, the heater will
automatically turn on again to maintain the preset
temperature level.
3. Press the Temperature Set button
G
a second
time to return the heater to Standby.
NOTE : It is normal for your heater to cycle on and
off to maintain the preset temperature. Raise the
temperature setting to prevent your heater from
cycling too frequently.