EPIC™
V Series
User Manual
pg. 38
5400430 Rev A
8.3 INSTALLING/REPLACING THE CONSOLE BATTERY PACK
1. To install or replace the battery pack, remove the battery cover on the underside of the
console using the Phillips screwdriver included with the laser system (Figure 8.1).
2. To remove the battery, grip the battery at the top and pull the cable away from the
connector (Figure 8.2). Do not tug or wrench the cable from the connector.
3. To install the battery, insert the connector wire from the battery to the unit, making sure
the red wire is on the left, and gently place the battery into the compartment (Figure 8.2).
4. Replace the battery cover on the bottom of the unit, using a standard Phillips
screwdriver.
5. Connect the power cord of the DC power supply to the unit and plug into a wall outlet.
Before first use, you should fully charge the battery (at least 3 hours). Once the battery is
charged, unplug the power cord from the wall outlet and the console. The unit will run on
battery power alone. (See Section 4.1)
6. Recycle the used Lithium Ion battery as regulated. Do not throw it in a trashbin.
Figure 8.1: Battery Cover/Bottom of Console
Figure 8.2: Battery Pack/Connector Wire
NOTE:
Only use the battery pack supplied by BIOLASE. The battery pack is a separate
accessory (BIOLASE p/n 6400457).
8.4 CHANGING THE WIRELESS FOOTSWITCH BATTERIES
The wireless footswitch is powered by two AAA batteries. When the batteries are low, a warning
message will appear on the touchscreen indicating that the batteries need to be replaced. To
replace the batteries, unscrew the battery cover on the underside of the footswitch (Section 3),
remove the old batteries, and install the new ones, replacing the cover when done. Dispose of
the used batteries as regulated; do not throw them in a trash bin.
Screws to remove
Battery cover
