13
Biodex Medical Systems, Inc. © 2017
Atomlab Wipe Test Counter
Connecting the Chamber:
•
Open the second carton and carefully remove the Wipe Chamber. Place it in the area where
it will reside.
•
Plug one end of RJ-12 Cable 3 into the Interface Module as illustrated in the circular inset at
the upper left of Figure 11 making sure that the open port is used. Plug the other end of the
RJ-12 Cable into the Wipe Chamber as illustrated in the circular inset at the bottom right of
Figure 11.
•
Connect the two sections of Cable 5 by plugging the cable into the power transformer (see
Figure 11). Place the power connector end of Cable 5 into the Interface Module as illustrated
in the circular inset at the upper left of Figure 11. Place the other end of the power cable
into the power strip.
Figure 11. Connecting the Wipe Test Chamber
Note:
Do not apply power to the Atomlab until all of the connections have been
completed.
Note:
If a printer is not being installed on the Atomlab 500, proceed to page 15.
(5)
