Side Rails (#058-631)
The side rails can be installed on both sides of the table.
Each rail pivots individually to assume either the raised or
lowered position. Both a left side rail and a right side rail
are supplied. They must be installed on the correct side of
the table.
Installing the side rails:
1. Using a 7/16" wrench, remove the four 1/4-20" hex head
screws from under the abdominal cushion (toward the
rear of the cushion) on the side of the table to which the
side rail will be installed.
2. Position the side rail support bracket against the bottom
of the cushion so the four pre-drilled screw holes in the
bracket align with the screw holes under the seat cush-
ion. The side rail should face up with the short end of
the rail closest to the foot end cushion.
3. Using a 7/16" wrench install the four screws removed in
step 1 through the side rail support bracket. Tighten
securely.
Using the side rails:
1. To raise either side rail lift up on the foot end of the rail
and pivot the rail toward the head end of the table until it
locks into place in the fully raised position.
2. To lower either side rail, pull the side rail pull pin toward
the head end of the table to disengage the pin. Pivot the
rail toward the foot end of the table until it assumes the
fully lowered position.
Figure 5. Installing the side rails.
- 8 -
