4
User Enrollment
3.3 Changing Master Code
PRESS:
0 + * + Default Master Code + New 8 Digit
Master Code + Repeat New 8 Digit Master Code + #
NOTE: The default Master Code is: 11111111
NOTE: When successful the lock will make a solid single beep. If
unsuccessful it makes 3 quick beeps.
HINT:
When entering the codes take a 2-3 second short pause between
codes.
Example: Master Code (pause) New 8 Digit Code (pause) Repeat New Code
When the Master Code has been changed, close the slide cover, open it
up & try the code to confirm your new code is working.
PRESS:
1
+
#
+
Master Code
+
#
NOTE: At this point the scanner will light up.
FIRST SCAN:
Place the 1st finger on the scanner and remove when
scanner light turns off.
SECOND SCAN:
Replace the same finger when scanner lights up for the
second time. You will hear a single beep if the enrollment is successful.
REPEAT:
You can keep adding fingerprints one after another at this stage.
HINT:
If a scan fails you will hear 3 beeps & the scanner goes off. Just
repeat the steps above.
3.4 Enroll Fingerprint Users at Random (No User ID’s)
NOTE: The scanner cover must be pulled up or the “#”
button pressed to power on the lock before adding,
deleting, or changing codes or fingerprint users.
The BioBolt evo3 will automatically exit out of
®
Programming Mode after 15 seconds. Please be sure to
wait 15 seconds after enrolling, modifying or deleting a
user before using the BioBolt evo3.
BioBolt
®
evo3 Biometric Deadbolt
http://www.bioboltlock.com | Intelligent Biometric Controls, Inc. | v1.1