BIO UV UV10, Installation And User Manual, Page: 4 / 84

BIO-UV
Copyright
BIO-UV
03/07/08
4
Safety Warning
NEVER LOOK AT THE ULTRAVIOLET LAMP WHEN LIT WITHOUT USING PROTECTIVE
GOGGLES AS IT COULD CAUSE SEVERE INJURIES, BURNS OR EVEN BLINDNESS.
NEVER UNDO THE STAINLESS STEEL TIGHTENING NUT WITH THE FILTRATION
RUNNING, AS THE QUARTZ SLEEVE COULD BE EXPELLED FROM ITS HOLDER AT
SPEED AND INJURE YOU
Before attempting to access the connection terminals, all power supplies should be
disconnected. If the cable is damaged, it must be replaced by a cable or special assembly
available from the after-sales service.
For your safety as an installer and/or user:
1. Read all the instructions in this manual before switching on the
BIO-UV sterilizer
2. WHEN REPLACING THE LAMPS AND/OR DURING THE ANNUAL CLEANING OF QUARTZ
SLEEVES, CHECK THAT THE ELECTRICAL PART IS IN PLACE AND CORRECTLY SECURED
BEFORE SWITCHING ON THE STERILIZER.
3. CHECK THAT THE NUT, WASHER AND O-RING (16-15-14) ARE CORRECTLY POSITIONED,
OTHERWISE THE QUARTZ SLEEVES COULD BE EXPELLED FROM THEIR HOLDER AT SPEED
AND INJURE YOU.
4. In order to avoid electrical short-circuits, never submerge electrical wires or the BIO-UV sterilizer
in the pool water or any other liquid
5. Disconnect the BIO-UV sterilizer before all maintenance and cleaning operations
6. Allow the ultraviolet lamps to cool before handling
7. DO not touch the ultraviolet lamps with bare hands. It would leave dirt on the lamps
which would reduce their service life. If you touch them, clean them using methylated
spirits or spirit vinegar
8. Do not operate the BIO-UV sterilizer if the power supply lead is damaged
9. Do not re-start the system without first checking that the electrical part and the sterilizer’s upper
unit are correctly back in place
10. Do not use the BIO-UV sterilizer for any other purpose than that for which it was designed