Operating Instructions at a Glance
Turning Power On
Press the POWER button on the left side of the Control Panel. The heater’s
quartz heating elements will light up inside the heater. After a few minutes,
once the air within the heater is warm, the heater fan will begin to operate.
Turning Power Off
Press the POWER button located on the left side of the Control Panel. The
sound of the heater fan will continue until the heat has been completely
vented, thus protecting the unit and preventing waste by cycling the remain-
ing heat into the room. (NOTE: DO NOT unplug the heater until the sound of
the fan has stopped. Doing so may cause damage to the unit.)
Setting the Temperature
This feature allows you to set the temperature that your heater will maintain.
1500PCPremium
: Press the temperature (TEMP) button on the Control
Panel; the SET TEMP indicator will illuminate and the temperature display
will flash. Use the UP and DOWN buttons to select the temperature and
press the ENTER button. The SET TEMP light will turn off.
1500PB
: Press the POWER button to turn the heater on. Press the UP or
DOWN button to move the temperature to the desired setting.
Setting the Timer (1500PCPremium)
This feature allows you to set a future time for the heater to turn itself on. For
example, if you set the time for 1 hour, the heater will turn on in 1 hour.
1. Turn the power off (heater must be powered off to use the timer feature).
2. Press the TIME button on the Control Panel—the two zeros to the right
will flash (:00), and the DELAY START indicator will illuminate.
3. Press the UP or DOWN button to select desired number of minutes (up
to 59 minutes) that you would like the heater to wait to turn itself on.
4. Press the ENTER button—the two zero buttons to the left will flash (00:),
indicating 0 hours have been set.
5. Press the UP or DOWN button to the desired number of hours (up to 24
hours), and then press the ENTER button.
6. DELAY START indicator will flash until the unit comes on after waiting
the period of time you have set.
7. To cancel the timer, press the POWER button and the timer will stop.
Switching Between Fahrenheit & Celsius
1500PCPremium:
Press and hold the DOWN & ENTER buttons for about 3
seconds.
1500PB:
Press and hold the POWER & DOWN buttons.
©2010 BioSmart Technologies
Page 12
