Binzel Neutrix, Instruction Manual, Page: 10 / 12

Page 10
7. Maintenance
Remove the plug from the power supply before carrying out any
maintenance or repairs.
7.1 Replacing the filter
The filter has to be changed when the amount of dust makes it difficult to
watch the grinding process through the inspection cover (29).
1. Loosen the allen screw (25.3) at the filter housing (25).
2. Remove the filter cover (25.2).
3. Remove the filter cassette (26) and put it into the plastic bag for
disposal.
4. Insert a new filter cassette so that the rubber seal is sitting tight to the
grinding head (2).
5. Mount the filter cover and tighten the screw.
7.2 Replacing the diamond wheel
1. Remove the electrode holder (5).
2. Loosen the knurled screw (22)
3. Unscrew the electrode holder guide (14) using the spanner (SW 17)
4. Remove the grinding chamber (10) including the inspection cover
(29).
5. Unscrew the nut retaining the diamond wheel, using the spanners
(SW14 & SW13), two flats are located on the motor spindle behind
the diamond wheel for this purpose.
6. Remove the diamond wheel.
7. Insert a new diamond wheel and replace the retaining nut.
8. Replace the grinding chamber and inspection cover
Replace the electrode holder guide
9. If the grinding head chamber is too dirty it can be cleaned with an
alkalised solution and rinsed with water.
If doing so remember to
remove the filter first