- 6 -
User Parameter Selection and Adjustment
The RX10K Receiver has seven user-configurable parameters.
The parameter name and value are shown on the lower line of the
display. Parameters are selected by scrolling through the
parameter menu using the
SELECT
◄►
(left and right) arrow
keys. The value of that parameter is adjusted using the
ADJUST
▲▼ (up and down) arrow keys. The parameter name is displayed
on the left side and the value on the right. A description of the
parameter screens and possible settings follow.
Channel
The Channel parameter allows the user to change the receiving
RF channel to match the RF channel of the TX10K. There are 16
RF channels. Appendix A contains a table listing the RF channels
and their corresponding frequencies. Along with the channel
selection value, a bar graph indicating the relative RF signal
strength being received is displayed. The more “=” units, the
better the signal strength (ten is maximum).
Input
The Input parameter allows the user to simulate certain inputs
from the TX10K. These can be used to check the operation and
settings of the RX10K, even without a transmitter. The possible
values are listed below:
Input
Description
Transmitter
The TX10K signal is the input
(normal operating
mode)
+FS
Positive Full Scale input is simulated
Zero
Zero level signal input is simulated
-FS
Negative Full Scale input is simulated
+FS/2
Positive half scale input is simulated
-FS/2
Negative half scale input is simulated
+FS/4
Positive quarter scale input is simulated
-FS/4
Negative quarter scale input is simulated
+00328 -_
_
_
_
_
█
_
_
_
_
_+
R
x
C
h:
1
=
=
=
=
=
=
=
=
=
=
+00328 -_
_
_
_
_
█
_
_
_
_
_+
Input:
T
ransmitter
Summary of Contents for TorqueTrak 10K-LP
Page 1: ...TorqueTrak 10K LP Torque Telemetry System User s Guide 869501 9_F ...
Page 2: ......
Page 45: ... 43 ...
