DPM-500 Analog Input Meter Instruction Manual
11
Connections
All connections are made to removable screw terminal connectors located at the rear of the meter.
Use copper wire with 60°C or 60/75°C insulation for all line
voltage connections. Observe all safety regulations. Electrical
wiring should be performed in accordance with all applicable
national, state, and local codes to prevent damage to the
meter and ensure personnel safety.
Connectors Labeling
The connectors’ label, affixed to the meter, shows the location of all connectors available with requested
configuration.
Warning!
Do not connect any equipment other than BinMaster
’s
expansion modules, cables, or meters to the RJ45
M-LINK connector. Otherwise damage will occur to the
equipment and the meter.
Figure 6. Connector Labeling for Fully Loaded DPM-500
Power Connections
Power connections are made to a two-terminal connector labeled POWER on Figure 6 on page 11. The
meter will operate regardless of DC polarity connection. The + and - symbols are only a suggested wiring
convention.
Figure 7. Power Connections
AC or DC
POWER
Required External Fuse:
5 A max, 250 V Slow Blow
POWER
+
-
