Some regulatory agencies prohibit the operation of HVLP spray guns above 10 psi nozzle atomizing pres-
sure. Users subject to this type of regulation should not exceed 10 psi (50 psi gun inlet pressure). See
Air
Pressure Recommendations
, page 6 and
General Spray Instructions
, page 4. It is recommended that the
nozzle test gauge (see below) be used to confirm actual nozzle operating pressure.
It may also be a requirement of some regulatory agencies that users have this gauge nozzle available on
site to verify that the gun is being operated within the limits of applicable rules.
IMPORTANT REGULATORY NOTE
Part Number
Description
54-3908*
900 SERIES
54-3935
95 and 97 SERIES, 95AP and 97AP
54-4078*
95AS and 97AS NOZZLES (Siphon)
54-4345*
90P NOZZLE
54-4356
93P NOZZLE
54-4066*
94P NOZZLE
54-4566
96G NOZZLE
*Available from Industrial Finishing distributors only.
59-299 Gauge
8
Sales and Service Through a Nationwide Network of Industrial Distributors.
Customer Service in USA / 1-800-992-4657
Technical Support in USA / 1-888-992-4657
195 Internationale Blvd.
Glendale Heights, IL 60139
Part Sheet 77-2665R-4 Printed in USA 7/03, All Rights Reserved
77-2665R-4 Revisions:
(P2) Updated diagrams to show new style extractor, added reference
to recommended extractor HFRL-508; (P4) Revised diagram and Parts List; (P5) revised Fluid
Nozzles chart; (P6) Removed references to #6 side port control; (P8) Updated list.
