Instruction Manual
Page 26 of 40
Issue: 2.1
N:\Engineering\Manuals\Pump Unit E2-30 & 40 R2.1.doc
Maintenance – Section 6.1 - Assembly Procedure
Main Drive Assembly
1. Place the Ø100 rubber ‘O’ ring (24) over the bearing cap (23) and place the
cap over the end plate bearing, making sure that the greasing port is at the
back of the pump assy. Fit the 6 off M6 x 20 cap screws (18) and washers
(19) using Loctite 222 on the threads and tighten in a diagonal pattern until
15Nm is achieved.
2. Fit a 45° push on grease nipple (25) into the grease port, and tighten until the
nipple faces the front of the pump assembly.
3. Assemble the two mounting legs (124) to the bottom plate, using M16 x 30
cap screws (126) and washers (125)