Bindicator SonoTracker Ultrasonic Liquid Level, Installation & Operation Manual, Page: 40 / 96

Note: The Sensor Key only works if you are at the “end” of a menu; i.e., where the screen allows you to enter a
value or select from a list of choices on the display. If you press the Sensor Key, the display changes to:
‘Enter’ to Copy
> 25.0 ft
Press the Up/Down Arrow Keys to switch to the previous channel (ID#01). When the display shows the desired
channel, press the Enter Key. For Next and Back, the controller display actually switches to the menu tree for the
selected channel.
If you do not want to switch channels but simply want to copy the Span you entered for channel 2 for use in
another channel(s), press enter for Copy. The controller then asks whether you want to copy the value to all other
channels or to a selected channel.
Sensor 1 App?
Tank Height?
Level Type?
Stand Pipe?
Transducer Freq
Warning
Operating Units
Continue w/Setup?
Set Temp?
Decimal Pace?
4-20mA?
Tank Height
If no temp
probe
detected
Warning:
sensor
perpendicular
to surface
LIQUIDS
Sensor 1
Up/Down/Enter
Warning
Figure 9: Level Parameters
QUICK CONFIGURATION PARAMETERS
At power-up in Level applications the parameters shown in
Figure 9
will appear. Selecting Yes allows the
entering of the second transducer parameters or continues to auto assign channels. Selecting No completes the
configuration of transducers and begins measuring. Once the Auto Assign mode is initiated, select Yes or No to
Auto Set Pts, Auto Point Level, Auto PLC or Auto 4-20? In Auto Assign Mode, you are assigning the following
per enabled channel for each transducer, if the PCB’s are installed:
Set Point: 1
4-20mA: 1
All are assigned sequentially. Press Enter to save. Quick Config is now completed.
36
www.bindicator.com
SON280020 Rev. C