3. EasyStar Installation
Figure 8: Installation diagram for the EasyStar retrofit system Here you see a double
unit with two turbines. Installation of a single-turbine unit works the same way.
Installation of the mounting bracket on the edge of the pool depends on on-site
conditions.
The EasyStar retrofit system is delivered on a bracket. Mount the bracket with the turbine
on the edge of the pool. Ensure that the centre of the turbine is roughly 30 centimetres
below the waterline (see Section 3.1 for further information). The electrical connection of
the turbines to the control system is described in Section 4.
•
These units are ready for installation and manufactured according to order instruc-
tions.
•
The mounting bracket/suspension device must be securely attached to the edge of
the pool.
•
No attachment at the pool floor is necessary.
•
The motor cable must be installed so that it cannot be damaged.
•
The housing must be completely under water.
•
Suction is performed from the sides of the unit. It must be ensured that the suction
slits are never clogged and that water flow is guaranteed.
Operating Manual Hydrostar V4.0
19
Summary of Contents for HydroStar BGA 160
Page 51: ......
