Binder 9040-0189, Operating Manual

Page: 71 / 119

CB-S / CB-S-UL (E7) 06/2020 page 71/119
•
Other event messages according to existing alarms
•
The moment of switching the alarm state on and off is indicated under “On/Off”.
17.2 Storage capacity
The storage capacity of the data recorder depends on the number of entries.
•
DL1 = 110.000 entries (equaling 76 days with a storage rate of 1 minute, setting see chap. 17.3)
•
DL2 = 27.000 entries (equaling 18 days with a fix storage rate of 1 minute)
•
Event list: 200 events
The shorter the set storage rate, the closer are the stored measuring points, the more precise, but also
shorter is the documented period.
Once the storage capacity of the data recorder is reached, overwriting of the oldest values begins.
17.3 Setting the storage rate for the “DL1” recorder data
Required access level: “Admin”.
Path: Normal display Settings Data recorder Storage interval
Press the OK button to enable the setting.
Function “Storage interval”.
The current setting flashes. Use the arrow buttons to enter the desired
storage interval. Setting range: 1 minute to 60 minutes.
Press the OK button to confirm the setting.
Storage interval
With the Back button you can go back to the “ Data recorder ” submenu and, repeatedly pressing it, to
Normal display .
17.4 Deleting the data recorder
When importing a configuration via USB stick (chap. 18.2) and when loading a new firmware version by
BINDER service, the entire data memory is deleted.
BINDER service can also install the configuration by means of a setup program without deleting the data.
Regardless of this, BINDER Service can delete the data via a setup program.
Loading a new configuration via USB-Stick leads to deleting the data recorder.
HINWEIS
Danger of information loss when loading a new configuration.
Data loss.

Backup data on the USB stick prior to loading a new configuration.