5
2 INSTALLING
YOUR
PHONE
2.1 Connecting the base station
1) Plug the power supply
and line cord
into
the base station.
2) Plug the power adapter into a 100-240V 50/60Hz
mains socket, and the line cord into your telephone
line socket.
3) Always use the cables provided in the box.
Warning:
Use only the provided power adapter, as others may cause a hazard.
Warning:
Install the base unit in a position where the mains adapter plug will reach
an easily accessible mains socket. Never try to lengthen the mains power cable.
Warning:
For pluggable equipment, the socket-outlet (power adaptor) shall be
installed near the equipment and shall be easily accessible.
Note:
The base unit needs mains power for normal operation, not just for charging
the handset batteries.
2.2 Installing and charging the batteries
1) Place the 2 supplied batteries into the battery compartment with the polarity
markings as shown. Use only the NiMH rechargeable battery type provided.
2) Position the battery compartment cover over the
batteries and slide up to click into place.
3) Put the handset on the base and charge for 15
hours before using the handset for the first time.
The handset will give a beep when it is properly
placed on the base or charger.
Note:
To charge a handset you can put it face-up or
face-down on the base or charger.
If you have a Broadband line
If you connect your telephone to a line with a
broadband connection, you will need to insert a
micro-filter between the telephone and the telephone line, otherwise you may get
interference between the telephone and the broadband, which could cause problems.
In a home with broadband, every telephone
must have a micro-filter connected, not just the
one at the telephone point that your modem is
connected to.
If you need more broadband micro-filters, contact
your broadband supplier.
