Binatone SI-2550, Instruction Manual

Page: 5 / 38

5 55 55
ENGLISH
INSTRUCTIONS FOR USE
1. Place the iron into a vertical position.
2. Insert the power plug (13) (13) (13) (13) (13) into the mains
supply outlet.
3. Turn the temperature control knob
(10) (10)
(10) (10) (10) to
set the temperature recommended by the
manufacturer of the textile article (usually
indicated on the article’s label).
Note: In case the manufacturer’s recommendations are
missing, select the temperature setting, which
corresponds to the type of the cloth to be ironed (see
section «Useful advice»).
4. The operation indicator (11) (11)
(11) (11)
(11) will light up to indicate that the iron
is being heated to the set temperature level. When the set tem-
perature level is reached, the light indicator (11) (11) (11) (11) (11) will turn off.
Note:
During operation of the appliance the light indicator
will light up and turn off periodically; this is normal
and not a malfunction.
Steam ironing
Dry ironing can be can be used at any temperature setting. To
do this the steam control knob (9) (9) (9) (9) (9) must be put into the «0» posi-
tion. If you intend to use the steam function, allow the iron to heat to
the required temperature level then put the control knob (9) (9) (9) (9) (9) into
the required position.
Attention: Application of the steam ironing function is
impossible at «•» temperature setting. SI-2550 iron: the
«Drip Stop» system automatically terminates the steam
generation process if the selected temperature is too low.
When the system is activated, you may hear a click.
Turbo steam
To ease ironing of dense cotton, linen and upholstery articles use
the steam burst button (8) (8) (8) (8) (8) : engagement of the button (8) (8) (8) (8) (8) during
the ironing process generates an extra burst of steam from the sole
plate to help remove stubborn creases.
Burst of steam in a vertical position
This function helps to freshen the appearance of curtains, jack-
ets, coats, etc. To use this function, take the following steps:
! Follow instructions in paragraph 1-4 of the section «Operation
instructions». While selecting the temperature setting, put the
temperature control knob (10) (10) (10) (10) (10) into the «Max» position.
!
While holding the iron in a vertical position, aim its sole plate
towards the articles to be ironed and push the steam burst button
(8) (8)
(8) (8) (8) to produce a directional strong burst of steam from the sole
plate. Push the button several times with 5-7 seconds intervals
until the article is fully refreshed. If during the process your water