4
1. Locating the Base unit
2.
Plug the coiled handset cord into the Handset. Plug the other end into
the jack on the left side of the Base unit.
3. Place the Handset on
the Base unit.
4. Plug the telephone line cord into
the PHONE LINE jack at the
end into your telephone line socket
5.
Plug the power supply cord into
the POWER jack at the bottom of
into a 230V AC, 50Hz mains
socket, with the switch on the
socket set to OFF
6.Switch ON the mains power at
the socket. Wait while the
7.Lift the Handset and check
Make sure
display shows INITIALISATION,
Answering machine on.
Announcement one
before
the display changes to the
“
”
standby screen.
bottom of the Base unit. Plug the other
Always use the telephone
line cord supplied with your
line cords may not work.
to Modular
Wall jack
for Dial tone in the earpiece
Note: The base unit doesn't require a battery.
the Base unit. Plug the other end
then the announcement
2. Installation
or extension socket.
Note:The Reliant 510
Base unit must be used
only the power adapter
supplied- 5E-AD070042-B.
the plugs click
into place.
Phone. Other telephone
The Base unit should be placed on a level surface, in a position where:
the mains adapter plug will reach an easily accessible 230-V AC
extension socket.
might get wet.
machines, microwave ovens, TVs, fluorescent lights, etc.
cable
.
the telephone line cable will reach your telephone line socket or
it is not close to a sink, bath or shower, or anywhere else where it
switched mains supply socket - never try to lengthen the mains power
it is not close to other electrical equipment - fridges, washing
