Binatone EK-1720, Instruction Manual

Page: 7 / 34

7
ENGLISH
7 . Your kettle has three kinds of functions: boil water,
keep warm and boiling extend. The selected mode is
shown on LCD (see fig. B) . You can change the current
function by pressing the Function switch (7) . At setting state,
the blue LCD lighting is switches on, the icon of the function
which will be selected is light.
8 . Default settings: boiling water to 100°C, no keep warm.
When set boil parameter, water temperature can be adjusted
from 40°C to 100
°C; one step is 5 °C. You can change the
current temperature by pressing the Tuning buttons (8) . Se-
lected water temperature will be shown on LCD.
9 . When set keep warm temperature , it can be adjusted
from 40 °C to 90 °C; one step is 5 °C. You can change the
current temperature by pressing the Tuning buttons (8) . Keep
warm time is less than 30 minutes. If no need keep warm, set
parameter to «00» is OK.
Attention: Keep warm temperature should be less than boil
water temperature, otherwise unit will adjust it by
itself.
10.When set boiling extend , extend time can be adjusted
from 3 sec to 6 sec. You can change the current time by
pressing the Tuning buttons
(8) .
Attention: This set is effective only based on boiling water
temperature is higher than 95 ° C.
11.Press the Heater activation knob (9) after setting state. At
working state, the icon of the working function is sparkling;
selected water temperature is shown on LCD. After starting of
heating, a blue light will light up inside the body
. Press the knob
(9) again, the appliance will go back to setting state.
12.The appliance will automatically turn off as soon as water reaches
installed temperature. The indicator light will switch off.
Attention: when heating or keeping warm, remove the body
from the power base, then place into position again, all
the previous settings will be canceled. Default settings
will be installed automatically (ref. to
«Default
settings»
sections). If you want to continue boiling or
keeping warm, you must set the program again.
13.If water goes cool, and you want to re-boil (or heat) it again,
turn the kettle on again.
MAINTENANCE
AND CLEANING
1. Before cleaning or storing disconnect the
kettle from the mains supply and wait till it
cools completely. The optimal range of sur-
rounding temperature is from 5 to 50°C.
2. To avoid electrical shock, do not place the
body of the kettle (1), its base (10) and
electrical cord in water. These parts of the