03
Helpline No. UK/Nor ther n Ir ela nd
Web Support
http://www.binatoneonline.com/
08453459677
0818762092
d.
Place the Action 1000 units in the charge cradle in an upright position.
The Charge LED indicators will light up.
completely run down.
New batteries take up to 14 hours to fully
charge.
Important:
Always turn off the PMR units
when charging. This will
shorten the charging time.
Mains socket
Then switch ON the mains socket.
The Action 1000 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the Action 1000 will
Important: Charge the unit for 10-14 hours.
Binatone Help Line - 0845 345 9677
e.
It takes about 10 hours to fully charge the batteries if they are
Charge
jack
Headset
jack
Plug the mains adaptor into a
240V AC, 50Hz main
socket with the switch
on
th
e
socket set
to OFF.
Use
only
the power supply
supplied with the Action 1000.
CAUTION : Risk of explosion if
the
battery is replaced
by an incorrect type. Dispose of used batteries according
to the instructions.
The Action 1000
has a
built in power save
function
to make the
ba
tteries last longer. But when you are not using the units,
turn them OFF to conserve battery power.
Insert the round connector of
the 9.0V DC/300mA adaptor
into the charge jack.
c ll
a
OR:
Charging the
batteries
directly
(using
the
adaptor)
Lift the charge socket cover located on the right
side of the handset.
The battery meter is located in the left
lower
corner of the LCD
Screen. It
look
s
like
a
battery
with
three
bars
inside.
These indicat
the
amount
of
power
available.
When
the
batter
y
level reaches
its
minimum level in PMR on mode, the unit will emit two beep tone
and automatically power off.
emit a “beep” sound every 10 seconds in normal mode.
Important: Charge the unit
for 10-14 hours.
Battery
charge
at
very
low level. When the battery
level reach
e
s its minimum level
during
on mode, the unit
will
emit two
"
beep
's"
and automatically turn off the
power.
