10/12
Before connecting the appliance, check that the voltage indicated on the data plate
correspond to those of the electricity network. In the event of incompatibility between the
plug point and the plug of the appliance, have the plug replaced with q suitable one by
professionally qualified personnel, who will make sure that the section of the wires of the
outlet is suitable for the power drawn by the appliance. In general, the use of adapters or
extension cords is not recommended; if their use is necessary, they must conform to existing
safety standards and their current capacity (amperes) must not be less than the maximum of
the appliance.
Before each use, check that the equipment is in good condition, that the power cord is not
damaged: if in doubt consult a qualified professional.
The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
Keep the appliance away from:
-
heat sources (e.g. open flame, gas stove, etc.)
-
liquid receptacles (e.g. sinks, etc.) to avoid water splashing onto the appliance or it
falling in (minimum distance of 2 meters)
-
fabrics (curtains, etc.) or floating materials that could obstruct the air intake grille;
make sure that the front is free of floating materials (dust, etc.).
The appliance must not be used in dusty environments or in the presence of floating
materials or used in a room where there is a fire risk.
Stand the appliance on a smooth, horizontal surface or table; do not place it on a inclined
surface (the appliance could fall over).
ASSEMBLY
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if
the power cord is damaged, it must be replaced by the manufacturer or a competent
qualified electrician or a person with similar qualifications, in order to avoid any risk.
If in doubt, have the appliance checked or assembled by a qualified professional person. For
assembly, refer to figure.
Attention: the fan can be used only when completely and correctly assembled, that is complete
with its base and protection grid.
Attention: always unplug the appliance before you assemble.
1)
Motor shaft
2)
Oscillation button
3)
Body
4)
Body attachment screw
5)
Pole attachment ring nut
6)
Feet attachment screw
7)
Foot
8)
Selector
9)
Adjustable pole
10)
Cover
11)
Fixed pole
12)
Front grille
13)
Fan attachment ring nut
14)
Fan
15)
Grille attachment ring nut
16)
Rear grille
17)
Handle
Stand
1.
Cross the two feet (7) and attach them to the fixed pole (11) with the 4 screws.