11/32
positioned incorrectly. Check that no other high absorption
appliances are connected to the same power source.
Do not use this heater the immediate surroundings of a bath, a
shower or a swimming pool.
The heater must not be located immediately below a socket-
oulet.
If the suppy cord is damaged, it must be replaced by the
manufacturer, its service agent or a similarly qualified persons in
order to avoid hazard.
The power socket must be easy to reach so the plug can be
removed quickly in case of emergency.
INSTALLATION
After removing the packing materials, check the integrity of the heater; if you are
unsure, do not use it and ask for qualified professional help. The packing materials
(plastic bags, polystyrene foam, nails, etc.) must be kept out the reach of children
because they are potential sources of danger.
Before connecting the appliance, check that the voltage shown on the data plate
matches that of your electricity. In the event of incompatibility between the electric
outlet and the plug of the heater, have the outlet replaced with another more
suitable type by professionally qualified personnel, who will make sure that the
section of the wires of the outlet is appropriate for the absorbed power of the
heater (10A). Check that the mains are not connected equipment; high absorption
to prevent overloading and fire risks. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to
existing safety standards and their current capacity (amperes) must not be less that
the maximum of the heater.
Attention: before use the appliance remove the detachable coupon to stick the
handle.
Before each use, verify that the heater is in good condition and that the electrical
cord is not damaged: in the case of doubt, ask for professionally qualified help.
Make sure that the cable is correctly positioned and that it is not in contact with hot
parts or sharp edges, nor wrapped around the device or twisted.
Position the fan heater far from other sources of heat, inflammable materials
(curtains, carpets, etc.), inflammable gases or explosive materials (spray cans) and
from materials that can deform on exposure to heat. Make sure that there is 100 cm
of free space in front of the fan heater and 30 cm on the sides. Do not use the
heater in the immediate vicinity of a bathtub, shower or swimming pool (to avoid
drops of water falling on the heater or the heater falling in the water), or in places
where it could be subject to shocks.
Do not hang or simply pull the unit to the wall or walls.
