17
9.
The appliance must be fixed to the floor by means
of 3 anchor flanges supplied. Make sure that there
are no pipes (electricity, water, gas, etc.) at the
points where holes are made. Drill holes into the
floor, insert the metal dowel (first remove the nut
and the washer, if previously positioned) until it is
fully seated, then insert the washer; position the
flange hole on the dowel and the other end on the
base (as shown below) and use the nut for locking.
OPERATION
The heater is equipped with a "pull" switch to select the power: 0/ Eco (800W)/ Comfort
(1200W)/ Rapid (2000W) using the string (9).
For the most convenient orientation of infrared and heat radiation, the inclination of the
heating unit can be adjusted using the two side handles (8). To switch off the heater, pull
the string down again.
If the appliance is not being used for long periods of time, remove the plug from the
socket.
