Bimar HC506, Instruction Booklet

Page: 23 / 92

23

Make sure that there are no internal pipes or wiring (electricity, water or gas, etc.) in
the appliance's mounting points.

Slightly unscrew 2 fixing screws “D” (4x12mm).

Mark the 4 mounting holes 280x158mm (WxH) apart: before making these holes, it
is best to check these measurements on the wall mounting bracket itself.

Drill the holes in the wall with a bit Ø8mm; fit the plastic expansion plugs fully into
the holes, then fix the mounting bracket with the 4 screws provided “A” (4x35mm).

Fit the convection heater on the wall mounting bracket and proceed as follows:
-
Tilt the bottom of the convection heater to about 45° so that the bottom slots “
” fit onto the bottom pegs of the mounting bracket “B”.
-
Lift the heater slightly so that the bottom pegs lock, then push it in so that its top
slots fit onto the top pegs of the mounting bracket “C”.
-
Press the appliance in with a moderate pressure until it click into place, then lock
by tightening the screws "D".

When done, check that the wall mounting bracket and convector heater are
securely fixed together.