The device can also be paired
using the “AP Mode”. Insert a
small tool or a pin fully into
the hole (1) in the rear and
press down for about five
seconds; the light on the front
will flash quickly. Access the
smartphone WI-FI settings
and connect to the “Bimar
Live Smart xxx” or “Smart Life
xxx” network, then press
"connect now".
In case the operations described above do not work correctly, you need to reset the device,
operating in this way: remove the device from the power supply and leave the device disconnected
for 30 seconds.
Connect the device to the power supply again, insert a small tool or a pin all the way into the hole
(1) in the back for about five seconds and the front light will flash quickly.
Settings and customisations.
Open the smartphone screen and press
in the bottom right corner to customise the following
functions: Home management,Message centre,Assistance centre,Configure (audio, alerts, info, cache
memory clear).
Press
in the bottom centre to customise operation of the device to suit the various scenarios or
operating situations provided by the APP (for example: Back home, Leaving home, Dawn, Goodnight,
Temperature, Humidity, Weather, Air quality, Dawn/dusk) or in combination with other devices.
Press
in the bottom left corner and then in the top of the screen, for example:
to
customise (update and/or change where permitted) the appliance's position or the outdoor wind
speed, air pressure, humidity and temperature (see right).
Press
top right to customise the following: Change Device name, Device position, Check Network,
Third-party devices upported: Amazon Alexa, Google Assistant, Device, sharing, Create a Comment
group, Device Info, Feedback, Update Firmware
The smartphone must be connected to Wi-Fi or cellular data network for remote control.
Voice control
The device is compatible with Amazon Alexa and Google Assistant voice controls. Open the
corresponding App/connect the Skill (make sure that the account and password used are the same
as those of the “Bimar Live Smart” app) and follow the settings.
Google Home: some basic vocal commands are:
-
“OK Google” or “Hey Google”, turn on XX (name of the device)
-
“OK Google” or “Hey Google”, turn off XX (name of the device)
-
etc.
Amazon Alexa: some basic vocal commands are:
-
“Alexa”, turn on XX (name of the device)
