BC26 HYDRO-DRIVE Owner’s Manual
Part No 501551
8
501551_A_HI
COMMON REPLACEMENT PARTS
•
Blade. P/N 501224. Original equipment replacement blade.
•
Transaxle Drive Belt. P/N 501268. Original equipment replacement drive belt.
•
Blade Drive Belt. P/N 501220. Original equipment replacement drive belt.
•
Skid. P/N 501407. Side deck skid.
•
Throttle Control Assembly. Throttle control including cable.
CLEANING
Your BILLY GOAT
®
Brush Cutter should be cleaned periodically to ensure optimum performance and service life. Clogs and
debris should be removed from the blade area and debris should be removed from the engine cooling fins. A garden hose or
pressure washer may be used for cleaning.
DO NOT SPRAY WATER DIRECTLY ON THE BLADE CLUTCH WHEN USING A POWER
WASHER. SEE FIG. 7.
NOTE
: Items in ( ) can be referenced in the Parts Illustrations and Parts Lists found at the back of the manual.
BLADE
SHARPENING
AND
REMOVAL
READ
all safety instructions before servicing unit.
1.
Disconnect spark plug wire.
2.
Lift and support front of unit to allow access to underside.
UNIT IS HEAVY
. Make sure support is adequate to support weight of machine.
3.
Block blade to prevent it from rotating during removal.
4.
Remove blade bolt (item 23), and friction washer (item 39).
5.
Remove blade (item 2) and install replacement blade. When replacing the blade use BILLY GOAT Industries PN
501224 only.
NOTE
: When sharpening blade make sure to sharpen all cutting edges. If the lock nut is removed and
replaced more than once, it should be replaced with a new lock nut (P/N 8160009).
6.
Attach new blade with new blade bolt (item 23), and new friction washer (item 39) removed earlier included with your
new blade.
NOTE
: Inspect fasteners for wear and replace if necessary.
7.
Torque blade lock nut to 40 ft-lbs.
8.
Reconnect spark plug wire.
DISCONNECT
spark plug wire before servicing unit.
Fig. 7
NOT
FOR
REPRODUCTION
