BC26EU HYDRO-DRIVE Owner’s Manual
Part No 501533
7
501533_-_HI
OPERATION
OPERATOR
CONTROLS
The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a position to allow
both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine. Operator’s controls are shown
below.
Operator Control Locations
1
Blade Clutch Lever
2
Forward Lever
5
Pull Starter
3
Reverse Lever
6
Choke
4
Throttle
STARTING
ENGINE
CHECK
engine oil level before operating machine.
DO NOT START
equipment with drive or blade clutch engaged.
3
1
4
2
5
6
1.
Place equipment on a level, firm surface that is free of rocks or other debris.
2.
Place throttle in “fast” position.
(See Fig. 1)
3
. Pull choke out (See
Fig. 2
Honda engine only).
4.
Units equipped with manual starters: Pull starter rope to start engine.
NOTE
:
PULL STARTER CORD slowly until resistance is felt. Then pull cord rapidly to
avoid kickback. (See
Fig. 3
)
5.
Push choke in (Honda engine only).
6.
Pull throttle control back to and allow engine to reach correct operating speed.
Fig. 1
Fig. 2
Fig. 3
NOT
FOR
REPRODUCTION
