Billy Goat B2601HMFT, Owner'S Manual

Page: 9 / 20

BC26 MECHANICAL DRIVE Owner’s Manual
Part No 501531 9 501531_A_HI
MAINTENANCE
PERIODIC MAINTENANCE
Periodic maintenance should be performed at the following intervals:
Maintenance Operation Every Use Daily or Every
5 Hours
Every 25
Hours
Every 50
Hours
Every 100-
150 Hours
Inspect for worn or damaged parts.

Check for excessive vibration

Inspect for loose parts. 
Sharpen blade. Note: the nut will need to
be replaced when blade is removed

Inspect belts for wear.

Lubricate throttle control cable and
linkage.

Check blade clutch cable tension.

Apply anti-seize compound to rear axles.

Replace blade drive and transaxle drive
belts.

COMMON REPLACEMENT PARTS
• Blade. P/N 501224. Original equipment replacement blade.
• Transaxle Drive Belt. P/N 501221. Original equipment replacement drive belt.
• Blade Drive Belt. P/N 501220. Original equipment replacement drive belt.
• Skid. P/N 501407. Side deck skid.
• Throttle Control Assembly. Throttle control including cable.
C
LEANING
Your BILLY GOAT
®
Brush Cutter should be cleaned periodically to ensure optimum performance and service life. Clogs and
debris should be removed from the blade area and debris should be removed from the engine cooling fins. A garden hose or
pressure washer may be used for cleaning.
DO NOT SPRAY WATER DIRECTLY ON THE BLADE CLUTCH WHEN USING A POWER
WASHER. SEE FIG. 7.
Fig. 7
NOT
FOR
REPRODUCTION