TECH LINE: 708-588-0505 FAX 708-588-7181 www.billetspecialties.com
Figure 6 - Install Crank Pulley, Water Pump Pulley
& Compressor Clutch Cover
Install the crank pulley by applying anti-seize to the threads of the three
3/8-24 x 1” socket head cap screws, install the three 3/8” Belleville washers
onto each cap screw and thread through crank pulley into damper.
Install the water pump pulley by applying anti-seize to the threads of the
four 5/16-24 x 1/2” socket head cap screws and threading them through the
water pump pulley into flange.
Install the compressor cover by applying anti-seize to the three 1/4-20 x 3/4”
socket head cap screws and threading them through compressor cover and
into compressor clutch.
Tighten all fasteners firmly.
Figure 5 - Install Alternator & A/C Compressor
Alternator:
Apply anti-seize to the threads of the 10mm-1.5 x 80mm ARP 12pt.
cap screw and the 8mm-1.25 x 25mm ARP 12pt. cap screw. Place alternator
between lower bridge bracket and alternator bracket and thread the long
ARP 12pt. cap screw through the bridge bracket, alternator and into the
alternator bracket and finger tighten. 10mm shim washers are provided to
shim the lower alternator boss to the bridge bracket. The alternator boss may
vary in width due to the polishing process. Place the 8mm slide spacer* on
the short ARP 12pt. cap screw, align top alternator boss with bridge bracket
and thread the cap screw with slide spacer through bridge bracket and into
alternator boss and finger tighten.
A/C Compressor:
Apply anti-seize to the threads of the 3/8-16 compressor
shoulder bolt and two 8mm-1.25 x 25mm ARP 12pt. cap screws. While
supporting the compressor, place the shoulder bolt and washer into the back
compressor mount boss and align with compressor bracket on motor and
finger tighten. Thread one 8mm ARP 12pt. cap screw through bridge bracket
and into lower compressor boss and finger tighten. Place the 8mm slide
spacer* on the short ARP 12pt. cap screw, align top compressor boss with
bridge bracket and thread the cap screw with slide spacer through bridge
bracket and into compressor boss and finger tighten.
*Flange of spacer fits into
adjustment slot on bracket.