7
Figure 4 - Install Power Steering Pump & Bridge Bracket
If you do not have power steering proceed to Step 2.
STEP 1:
Apply anti-seize to the threads of the two 5/16-24 x 3” socket head
cap screws. Place power steering pump and pulley onto bracket and thread
the two 5/16” socket head cap screws with 5/16” lock washers through pump
into bracket and tighten firmly.
STEP 2:
Apply anti-seize to the threads of the four 8mm-1.25 x 25mm 12pt.
ARP cap screws. Align bridge bracket mount holes with the four spacer nuts.
Install the four 8mm 12pt. ARP cap screws and tighten firmly.
TECH LINE: 708-588-0505 FAX 708-588-7181 www.billetspecialties.com
Figure 3 - Install Water Pump
Install water pump onto studs (make sure O-rings are still seated).
Apply anti-seize to exposed stud threads. Thread the three 2-11/16 spacer
nuts onto the short studs with the hex end out.
Thread the remaining 1-7/8” spacer nut to the passenger side bottom stud.
Tighten all spacer nuts firmly at this time. Also tighten lower 3/8” cap screws
on alternator bracket or power steering bracket.