84
DS440IS
6.11
Entry/Exit Functions with Data Recall
This type of procedure is enabled during the installation phase.
The two weighing phases for entry and exit do not necessarily have to be consecutive. The
difference between the entry and exit weights can be calculated at the time of the second weighing.
6.11.1 Entry weighing procedures
For each entry print-out, the terminal allocates and prints out a code (the RCD code). If this is
entered before the second weighing, the data from the first weighing (weight, product code, client
code and the vehicle licence plate) are retrieved.
To obtain a print-out of the entry weight, or first weight:
enter the required auxiliary data: product code, client code and vehicle licence plate (if such data
need to be recorded);
You are advised to use the shortcut keys
PROCOD
,
CLIENT
and
PLATE
and refer to the Use of the
Terminal chapter of the user manual to enter the numerical and alphanumerical data.
Otherwise use these paths:
...>MENU>Data Management>Code Management>Product Code
...>MENU>Data Management>Code Management>Client Code
...>MENU>Data Management>Code Management>Plates
make sure that the printer is connected, switched on and the paper has been loaded;
press
for a print-out of the first weight.
Printing will take place only if:
the weight stabilises within 10 seconds;
the weight is not negative or over the maximum weight capacity.
