2500W SHREDDER
BBB202SHR
and allow the machine to stop. Discon-
nect from supply and take the follow-
ing steps:
- inspect for damage.
- check for and tighten any loose parts.
- have any damaged parts replaced or
repaired with parts having equivalent
specifications.
7) Do not allow processed material to
build up in the discharge zone; this
may prevent proper discharge and can
result in kickback of material through
the feed intake opening.
8) If the machine becomes clogged, shut-
off the power source and disconnect
from supply before clearing debris.
Keep the power source clear of debris
and other accumulations to prevent
damage to the power source or pos-
sible fire. Remember that operating
the starting mechanism on engine
powered machines will still cause the
cutting means to move.
9) Keep all guards and deflectors in place
and in good working condition.
10) Do not tamper with the power source
governor settings; the governor con-
trols the safe maximum operating
speed and protects the power source
and all moving parts from damage
caused by over-speed. Seek autho-
rised service if a problem exists.
11) Do not transport this machine while
the power source is running.
12) Shut off the power source and discon-
nect from supply whenever you leave
the work area.
13) Do not tilt the machine while the pow-
er source is running.
14) When feeding material into the prod-
uct be extremely careful that the
mains cable is not accidently fed into
the product.
15) Keep hands and feet away from the
cutting means at all times and espe-
cially when switching on the motor.
16) Do not touch the cutting means before
the machine is disconnected from the
supply and the cutting means have
come to a complete stop.
17) Whilst using the product ensure the
cable does not become trapped under
the wheels or support feet.
4) Maintenance and storage
1) When the machine is stopped for
servicing, inspection, or storage, or
to change an accessory, shut off the
power source, disconnect form sup-
ply, make sure that all moving parts
have come to a complete stop and,
where a key is fitted remove the key.
Allow the machine to cool before mak-
ing any inspections, adjustments, etc.
2) When servicing the cutting means be
aware that, even though the power
source will not start due to the inter-
lock feature of the guard, the cutting
means can still be moved by a manual
starting mechanism.
3) use only approved replacement parts.
5) Additional safety instructions for
units with bagging attachments
1) Shut-off the power unit before attach-
ing or removing the bag.
