REM
E
M
B
ER TO
USE THI
S
ASSEM
BLY
PROCEDURE FOR HEX BOLTS
FLAT W
ASHER
LO
CK W
ASHER
HEX BO
LT
T-
NUT
Using 1 Hex Bolt 5/16" x 4 " (5/16" T-Nut, Washer, and Lock Washer), attach loosely leaving a gap
the Floor Support (5/4" x 4" x 39 1/2") to the Post SW (5/4" x 4" x 81").
1 pc 5/4x4x3-1/2" SW Block
Using 2 Wood Screws (#8 x 3") attach 1 SW Block (5/4" x 4" x 3 1/2") to bottom of
between the Post SW (5/4" x 4" x 81") and the SW Post (2" x 4" x 80 1/2") as shown in the diagram below.
Using 1 Hex Bolt 5/16" x 4 1/2" (1/4" T-Nut, Washer, and Lock Washer),
1 pc 2x4x80-1/2" SW Post
the SW Post (2" x 4" x 80 1/2"). Refer to the diagram below.
Using 2 Hex Bolts 1/4" x 2" (1/4" T-Nut, Washer, and Lock Washer), attach
attach the Floor Support (5/4" x 4" x 39 1/2") to the SW Post (2" x 4" x 80 1/2"),
as shown in the diagram.
HARDWARE LIST
2 pcs 1/4x2" Hex Bolt
2 pcs 1/4" T-Nut
2 pcs 1/4" Flat Washer
2 pcs 1/4" Lock Washer
1 pc 5/16x4-1/2" Hex Bolt
1 pc 5/16x4" Hex Bolt
2 pc 5/16" T-Nut
2 pc 5/16" Flat Washer
2 pc 5/16" Lock Washer
2 pcs #8x3" Wood Screw
WOOD PARTS LIST
1 pc 5/4x4x39-1/2" Floor Support
2 pcs 5/4x4x81" Post SW
Step 11
Assemble Swing End
5/4" x 4" x 39-1/2"
#8 x 3"
5/16 x 4-1/2"
Wood Screw
after the Floor Support is attached
NOTE! Do not tighten the Hex Bolt until
Hex Bolt
Floor Support
5/4" x 4" x 3-1/2"
SW Block
Hex Bolt
1/4 x 2"
5/16 x 4"
Hex Bolt
Post SW
5/4" x 4" x 81"
SW Post
2" x 4" x 80-1/2"
Post SW
5/4" x 4" x 81"
Summary of Contents for F24068
Page 10: ......
Page 27: ...NOTES...
