16
• Use a spray stand corresponding to each spray can.
6.2.1 Spray Stands
Rear Cover (R)
Spray Stand
1. Open the rear cover (R).
2. Depending on a spray can’s volume, the correct orientation of the
spray stand differs.
Check the spray can volume and make sure the protrusion hub in
the middle of the spray stand is correctly facing up or down, de-
pending on the spray can as shown in the table below, and then set
it straight down.
To replace the spray stand, remove the old stand by pulling it straight
up and then install the new one by setting it straight down.
█
Setting
█
Removing
(Facing Up)
Bottom Surface
Top Surface
(Facing Down)
